Direct Ignition Coil

YEC Flamma 90919-A2001 Direct Ignition Coil

Restore crisp, predictable ignition timing and clear your dashboard check engine warnings with the genuine factory-original YEC Flamma 90919-A2001 Direct Ignition Coil. The ignition coil transforms your vehicle’s low-voltage power into the high-voltage electrical spark required to fire the spark plugs and ignite the air-fuel mixture inside the combustion chambers. Over time, internal winding insulation breaks down and electrical pins corrode from exposure to extreme under-hood heat cycles, resulting in engine misfires, a rough idle, reduced fuel economy, or hesitation upon acceleration. Choosing this precision-engineered Japanese component guarantees full system reliability and seamless electronic compatibility without the risks of universal aftermarket alternatives.

Japanese Craftsmanship for Flawless Ignition Performance

Manufactured in Japan under the strict quality standards dictated by YEC Flamma, the 90919-A2001 direct ignition coil features high-grade copper windings and premium resin insulation protected by a robust, heat-resistant housing. This heavy-duty casing completely seals out moisture, oil leaks, and thermal stress that typically cause premature failure in low-quality coils. Its precisely calibrated internal resistor ensures zero signal lag, allowing your vehicle’s powertrain control module (PCM) to deliver optimal spark energy instantly across all operating ranges.

Key Features & Performance Benefits

• 100% Made in Japan: Manufactured using advanced electronics and premium materials for maximum durability and long-term reliability.
• Eliminates Engine Misfires: Instantly resolves diagnostic trouble codes (DTCs) related to cylinder misfires, hesitation, and rough idling.
• Direct Plug-and-Play Installation: Engineered to match factory mounting points and electrical harness connectors for a simple, secure bolt-on fit.
• Advanced Thermal Resistance: High-integrity housing protects internal circuitry from extreme engine temperatures, preventing voltage breakdown.

Installation and Maintenance Note

Before installing your new ignition coil, inspect the wiring harness connector for any signs of oil contamination, corrosion, or brittle locking tabs, as a damaged connector can disrupt electrical current and shorten the life of the new part. Always apply a small amount of dielectric grease inside the rubber boot to seal out moisture and prevent the boot from sticking to the spark plug. Please verify your vehicle’s part number or VIN to ensure complete drivetrain compatibility.

Vehicle Compatibility Table

Please review the compatibility list below to confirm this part fits your vehicle’s specific year, make, and model: